Formlabs Form Wash
Automate Cleaning with Form Wash
Parts travel straight from the Form 2 to
Formlabs Form Wash. Opt to go glove-free and keep
parts directly on the build platform.
Set it and Forget it
Simply set the appropriate time and let
Form Wash get to work.
15 MINUTES
Approximate wash time when using
fresh isopropyl alcohol (IPA)
8.6 LITERS
IPA volume for removeable
wash bucket
70 PRINTS
Amount of prints per IPA refill
in regular use
While you’re away, parts are precisely
agitated in IPA, getting every nook
and cranny perfectly clean.
A Consistent,
Automated Workflow
Once washing completes, Form Wash
automatically lifts parts out of the IPA,
avoiding over-soaked, warped prints. Parts
air dry and are ready when you are.
Specifications
- Platform Mount. Holds the build platform when washing parts on the platform.
- Basket. Holds parts to wash without the build platform.
- Basket Mount. A single hook secures the basket to raise and lower.
- Outer Lid. Limits IPA evaporation. Keep the lid closed when not in use.
- Inner Lid. A hinged, secondary lid opens and closes to contain IPA while allowing parts to be lowered or raised from the bucket.
- Wash Bucket. Removable container holds a maximum of 8.6 L of IPA. A rotating impeller at the bottom circulates IPA.
- Display. Shows status, time, and options for configuring Form Wash.
- Knob. Turn or push to adjust time and to start, pause, or end a wash cycle.
- Tool Storage. Each side has designated locations for storing each tool.
- Power Supply. Provides power to Form Wash. Specifications: 24 V, 2 A
- Isopropyl Alcohol (IPA). Not included. Dissolves liquid resin from printed parts’ surfaces. Start with 10 L. Concentration must be 90% or higher.
Other Resin 3D Printers and Accessories
